Metalcloak: welded correction bracket rear control arm DB3 – 2007-18 Jeep Wrangler JK

Description

The MetalCloak Jeep JK Weld On”DB3″ Rear Control Arm Correction Bracket System is the best solution to convert your long arm system back to a mid arm set up.
Features Include:
– Fits JK Wranglers
– 3/16″ Steel
– CAD Designed
– Laser Cut
– Ready To Be Welded
– Fixture Spacers Included
– Angled for Approach & Departure
– Trail-Tested Built-In Skid Plate
– Raw Metal Finish
– Made in the USA
The MetalCloak DIY weld-on bracket allows for you to convert your rig back to a mid arm set up and
re-positions the rear control arms to operate within a corrected radius. This system drastically reduces the feel of bump-steer/axle steer on lifted Jeeps and provides handling characteristics comparable if not better than a stock height Jeep.
The Weld-On DB3 welds directly to the stock location of the factory rear control arm frame brackets that were cut off when installing a long arm kit. The weld on DB3 allows you to fully weld the bracket to the frame and is angled for approach and departure when off-roading. The weld on DB3 comes with fixture spacers that allow you to adjust the parts perfectly to the frame so you know the bracket is aligned when welding.
Feel the improvement in acceleration, braking, climbing and steering performance with the DB3. The DB3 is only available from MetalCloak.
Note:
This alignment bracket is designed to be used with Adjustable rear control arms. Not to be used with stock control arms.
Note:
This is a weld-on DIY product. Do not purchase this product unless you are prepared to weld onto your Jeep.
Note:
Builder Parts are intended for your own custom application. There is no implied warranty or instructions for the use of these products; if using any of the builder parts you should be confident of your mechanical skill level and know that you will use at your own risk.