Metalcloak: front welded Duroflex bracket + axle bushing – 1997-06 Jeep Wrangler TJ / 2004-06 Jeep Wrangler LJ

Description

MetalCloak’s Front Duroflex Weld-On Bracket and Axle Bushing Kit. Replace the factory Clevite bushings by installing a reinforced and gusseted insert and Duroflex Kevlar enhanced bushings for your Jeep TJ Wrangler.
Features Include:
– Duroflex Joints
– Press In Housing
– Tower Gusset
– Retaining Washers
– Retaining Clip
– All Hardware Required
– Maximum Rotation & Articulation
– Made in the USA
Factory Clevite bushings will work in conjunction with Duroflex bushings. however, they have a very limited range of performance.
Optimize the Duroflex joints in your
MetalCloak control arms and fully benefit with Increased dampening NVH
(noise/vibration/harshness)
, more misalignment for articulation
(34 degrees per end)
and Rotation
(360 degrees)
. When you upgrade your bushings this also strengthens the weak stock tower-housing with the MetalCloak Front Duroflex Weld-On Bracket and Axle Bushing Kit!. Better bushings bushings and more strength!
MetalCloak’s Front Duroflex Weld-On Bracket and Axle Bushing Kit ONLY works with MetalCloak’s Duroflex Control Arms.
The Front Duroflex Weld-On Axle Bushing Kit comes complete with a press-in Duroflex bushing for the cast side and a reinforced weld-on bracket to contain the Duroflex Bushing on the other side.
Note:
MetalCloak’s Front Duroflex Weld-On Bracket and Axle Bushing Kit ONLY works with MetalCloak’s Duroflex Control Arms. MetalCloak’s Front Duroflex Weld-On Bracket and Axle Bushing Kit is not recommended for any other control arms.